Pipe Hangers & Support Hardware

Non Conductive Pipe Rollers prevent the passing of current from the pipeline to bridge structure and rebars. As a direct replacement for a cast iron roll, non-conductive pipe rollers are made of the highest specification polyurethane compound which is cast around an integral steel sleeve to form a full length bearing for the axle.

Add to RFQ

Adjustable Roll Hanger Includes:

1 Steel Clevis (Yoke)

1 Cast Iron Roll (Omit When Ordering Non-Conductive Roller)

Add to RFQ

Material: Spring cushion hanger consists of a set of two springs and four retainers only.

Service: Generally used with a single pipe roll. Recommended for installation where the vertical movement does not exceed 1 1/4 inches.

Approvals: Complies with Federal Specification WW-H-171E (Type 50) & Manufacturers Standardization Society SP-69 (Type 49).

Maximum Recommended Load is 300 lbs.

Add to RFQ

Adjustable Roll Suport Includes:

2 Adjustable sockets - 1 Roll Axle

2 Vertical Threaded Rods - 8 Hex Nuts

1 Cast Iron Roll (Omit When Ordering Non-Conductive Roller)

Add to RFQ

Roller Chair Includes:

1 Steel Base

2 Bolts & Nuts

1 Cast Iron Roll (Omit when ordering Non-Conductive Roller)

 

Add to RFQ

Adjustable Roll Guide Includes:

4 Adjustable Sockets

2 Roll Axles

2 Vertical Threaded Rods

12 Hex Nuts

2 Cast Iron Rolls (Omit When Ordering Non-Conductive Rollers)

 

Add to RFQ

Adjustable Roller Stands, used in conjunction with Non-Conductive Rollers, offer an alternative to the epoxy type pipe chocks for preventing or correcting crevice corrosion problems. The polyurethane based Non-Conductive Rollers will not abrade the pipe’s coating and allows moisture to drain away from the bottom of the pipe. Non-Conductive Rollers do not contact enough of the pipe surface to allow moisture or organic materials (grass clippings, leaves, pine needles, etc) to collect at the pipe roller interface. Non-Conductive Rollers are particularly useful on pipes that show significant expansion and contraction.

The Adjustable Pipe Roll Stand generally includes a galvanized cast iron base, steel plate, adjusting bolts and Non-Conductive Roller with stainless steel sleeve. The base can also be fabricated from carbon or stainless steel to standard or non-standard specifications. Available for pipe sizes 2” through 24”.

Add to RFQ

Pipe Roller Stand Includes Cast Iron Base, 1 Roll Axle, 1 Cast Iron Roll (Omit when ordering Non-Conductive Roller)

 

Add to RFQ

SIngle Pipe Roll Includes:

2 Adjustable Sockets

1 Roll Axle

Add to RFQ
Subscribe to Pipe Hangers & Support Hardware